
Bathroom Remodeling
Bathroom Remodeling
Read more403 Navaho Dr, Frederick, MD 21701

Shut-off valve replacement costs in Maryland
A seized main shut-off costs nothing until the day a supply line lets go, and then it costs a ceiling. Replacing it is one of the cheapest plumbing jobs in a house, and the price depends less on the valve than on what it is soldered, threaded or crimped into.
Quick answer
Replacing a main water shut-off valve in Maryland costs $320 to $780 with a licensed plumber. A fixture shut-off under a sink or toilet is $110 to $240 each, a pressure reducing valve $340 to $720, and a frost-proof hose bib $185 to $420. Doing several valves in one visit lowers the cost of each, because most of the price is the call-out and draining the system.
Estimates only — any figure above is a published range, not a quote. Your price comes off a walkthrough and arrives in writing.
The numbers
Almost no contractor site in this market publishes a number, which is exactly why the question has so much search demand and so little honest supply. These are the ranges we price to in Maryland, with the reason each one is a range and not a price.
Typical in Maryland
Main shut-off valve, replaced
$320 – $780
Estimate only — not a quote
$320 – $780
A full-port quarter-turn ball valve where the water enters the house. The bottom of the range is accessible copper; the top is a corroded galvanised connection that has to be cut back to sound pipe.
$180 – $360
Added in the same visit where the layout allows, so there is a second place to isolate the house if the first valve ever fails. Priced as an addition, not a separate call-out.
$110 – $240
Toilet, basin, kitchen sink, dishwasher or washing machine. The figure falls toward the bottom of the range when several are done together.
$650 – $1,600
Every stop in a typical two or three bathroom house changed in one visit. The per-valve cost here sits well under the single-valve price.
$340 – $720
Fitted or replaced where incoming pressure reads above about 80 psi. Measured with a gauge first, never assumed.
$150 – $350
Usually required once a pressure reducing valve closes the system. The same band the plumbing service page quotes for one added at water heater replacement.
$185 – $420
Replacing an exterior tap that has split over a Maryland winter, with its own interior shut-off. Higher where the wall is brick or the run is long.
$480 – $1,600
A failing run of galvanised steel or polybutylene replaced in copper or PEX. Access decides the price, not the length.
$2,200 – $4,800
Where the supply is failing throughout rather than in one place. Counted per bathroom because the number of fixtures drives the work.
$350 – $1,400
Only where a valve or run sits behind a finished wall or ceiling. Our own crew closes it up, so this is a line on the same estimate rather than a second contractor.
Estimates only. Every figure on this page is a published range, not a quote and not an offer. Your price is the one written on your own estimate, after someone has walked the job — access, condition, height and finish level move a number more than square footage does. Written estimates are free. Published 2026 and reviewed against work we are actually pricing in Maryland.
Older houses in Frederick County were plumbed with multi-turn gate valves. Over twenty or thirty years scale builds on the gate and the stem, and a valve that is never exercised either refuses to turn or turns and does not seal. Most homeowners find this out on the day they need it, with water already on the floor.
The replacement is a full-port quarter-turn ball valve, which closes with a single movement of the handle and has no gate to scale up. It is the single cheapest piece of insurance in a plumbing system, and it is what every other plumbing repair in the house relies on.
Test yours before you need it. If the handle will not move with reasonable hand pressure, or the water keeps running once it is closed, it is time to replace it rather than force it, because a forced valve that snaps is an emergency call rather than a planned one.
A visit to change the main already includes the call-out, the shut-down and the draining. Adding the fixture stops under every sink and toilet at that point costs a fraction of what each would cost alone, and it means any future repair in the house can be isolated at the fixture rather than at the main.
It is also the moment to check pressure with a gauge. If it is running high, a pressure reducing valve protects every new valve that has just been fitted, and an expansion tank keeps the water heater relief valve from weeping once the system is closed.
Hose bibs that have split over the winter belong on the same list, because they share the same shut-down. The result is one written estimate and one visit rather than four separate call-outs over four years.
Galvanised steel corrodes from the inside, and the connection at the main is often where it is weakest. If the pipe crumbles when the old valve comes off, the honest answer is to replace back to sound material, and that is a supply line section rather than a valve.
Polybutylene, the grey plastic used from the late seventies to the mid nineties, fails at its fittings with very little warning. Where a valve change reveals it, we price replacing the run in copper or PEX as a separate line so you can decide with both numbers in front of you.
In either case the plumbing is done by a licensed Maryland plumber, and where the run crosses finished space our own crew opens and closes the wall. That keeps the job with one contractor and one estimate.
Before you sign anything
Ask every contractor for these in writing. Quotes only compare once they do — and Maryland law requires home improvement work over $500 to be under a written contract anyway.
Want the number for your house?
Call and describe the job. You’ll get a straight answer on whether it’s something we do and roughly what it runs, before anyone books a visit.
(301) 524-1729
Priced by us, not a calculator
Plumbing
What moves the number
Usually not because one contractor is expensive. Usually because they are pricing different work. These are the variables that actually move it.
A valve on clean copper is cut out and replaced in under an hour. A valve threaded onto galvanised steel that has corroded from the inside often means cutting back to sound pipe and transitioning to copper or PEX, which is what moves a main valve from the bottom of its range to the top.
To change the main shut-off, the water has to be stopped before it. If the curb stop at the property line is seized or buried, the utility has to operate it, and in some jurisdictions that is an appointment rather than a phone call. It does not usually change the price much, but it changes the date.
Most of the cost of a single valve is getting there, shutting the house down, draining it and bringing it back up. The fourth valve in a visit costs a fraction of the first, which is why we suggest doing every stop in the house at once rather than one at a time as each one fails.
Pressure above about 80 psi is the quiet reason valves, flex lines and water heater relief valves fail early. Where the gauge reads high, a pressure reducing valve and usually an expansion tank join the estimate, and they are cheaper than the leaks they prevent.
Valves are almost always reachable. Supply runs are not always, and a run through a finished second floor costs more to reach than to replace. That is why access is priced on its own line rather than buried in the plumbing figure.
Straight answers
Not covered here? Call and ask — you’ll get a real answer, not a “depends on the job”.
Between $320 and $780 with a licensed plumber. The bottom of that range is a valve on accessible copper; the top is a corroded galvanised connection that has to be cut back. Adding a second valve beyond the meter in the same visit is $180 to $360.
Yes, by a wide margin. A single fixture valve is $110 to $240, but a whole-house package covering every stop in a typical two or three bathroom house is $650 to $1,600, because the call-out, the shut-down and the draining are paid for once.
Only if a gauge says so. Above about 80 psi a pressure reducing valve at $340 to $720 protects every valve and appliance downstream, and once it is fitted an expansion tank at $150 to $350 is usually needed too. Below that pressure we will not sell you one.
Most likely it is an old multi-turn gate valve that has scaled up after years without being used. Do not force it with a wrench, because a snapped stem turns a planned job into an emergency. Replacing it with a quarter-turn ball valve is the fix, at $320 to $780.
Usually not. Main valves and fixture stops are almost always reachable. Where a supply run behind a finished wall or ceiling has to be replaced, the opening and the making good are priced on their own line at $350 to $1,400, and our own crew does that part.
Estimates only — any figure above is a published range, not a quote. Your price comes off a walkthrough and arrives in writing.
While the crew is there

Talk to the people doing the work
Tell us what needs doing. We’ll walk it with you, sequence every trade it touches, put the price in writing, and leave you to decide.
Get a quote
Two short steps. No obligation, no pressure — just a clear number and a straight answer about what the job involves.




Tick as many as you like. Most jobs are two or three of them at once, and I sort out the detail when I come and look. Nobody gets turned away for choosing the wrong box.
“Excellent service! I called A&S Home Solutions for a bathroom remodel and some concrete job done and he was able to get to me and schedule an appointment all within a week. Reasonable price and fast job. Highly recommend!”
Michael Diaz
Bathroom Remodeling · November 2026
“As home solutions llc They did à great job for us in frederick Quick respons and quality Word Best experiance.”
Sergio Ramirez
Frederick, MD · November 2026
“Hi my name is [Darlin], I want to recommend .As home solutions Md LLC they are doing a great job in my house in Chantilly, Virginia I really appreciate the high-quality work best experience and affordable price.”
Darlin Castaneda
Chantilly, VA · November 2026
“As home solutions md they did a great job for us in frederick md we Highlight recomended for drywall intallations repair etc.aforable price great experins work with them”
Wagner Castaneda
Drywall Installation · Frederick, MD · November 2026
“Excellent service! I called A&S Home Solutions for a bathroom remodel and some concrete job done and he was able to get to me and schedule an appointment all within a week. Reasonable price and fast job. Highly recommend!”
Michael Diaz
Bathroom Remodeling · November 2026
“As home solutions llc They did à great job for us in frederick Quick respons and quality Word Best experiance.”
Sergio Ramirez
Frederick, MD · November 2026
“Hi my name is [Darlin], I want to recommend .As home solutions Md LLC they are doing a great job in my house in Chantilly, Virginia I really appreciate the high-quality work best experience and affordable price.”
Darlin Castaneda
Chantilly, VA · November 2026
“As home solutions md they did a great job for us in frederick md we Highlight recomended for drywall intallations repair etc.aforable price great experins work with them”
Wagner Castaneda
Drywall Installation · Frederick, MD · November 2026
“Amazing work with some drywall repairs I needed and helped changed the deck looks fantastic. Alfredo answered fast with a quote and got ready to do the job the following week, highly recommend!”
Estefany Estrada
Drywall Repair · October 2026
“A&S completed a ceiling repair for us. Must say it’s absolutely perfect! Thanks so much for quickly responding Alfredo and the quality workmanship.”
Robert Litterini
Ceiling Repair · August 2026
“Best service affordable prices”
Juana Delgado
Painting · July 2026
“This company make a really good job, I highly recommended.”
Kimberly De Leon
July 2026
“Amazing work with some drywall repairs I needed and helped changed the deck looks fantastic. Alfredo answered fast with a quote and got ready to do the job the following week, highly recommend!”
Estefany Estrada
Drywall Repair · October 2026
“A&S completed a ceiling repair for us. Must say it’s absolutely perfect! Thanks so much for quickly responding Alfredo and the quality workmanship.”
Robert Litterini
Ceiling Repair · August 2026
“Best service affordable prices”
Juana Delgado
Painting · July 2026
“This company make a really good job, I highly recommended.”
Kimberly De Leon
July 2026